SCOUG-HELP Mailing List Archives

<< Previous Message << >> Next Message >>

Date:	Wed, 17 Oct 2007 22:22:46 -0700
From:	Ray Davison <raydav@charter.net >
Reply-To:	scoug-help@scoug.com
To:	scoug-help@scoug.com
Subject:	SCOUG-Help: USB kills NET

Content Type: text/plain

Ray Davison wrote:
> Ray Davison wrote:
>> Ray Davison wrote:
>>>
>>> In one way this USB is better that W2K. In W2K when I plug in this
>>> four bay card reader it creates four drive letters, even if no cards
>>> are plugged in. When I do plug in a card I then have to try the
>>> drives till I find the one in use. eCS waited until I plugged in a
>>> card and created one drive. If I pulled the card the only change is
>>> the eject button disappears. The drive stays. When I unplug the bay
>>> the drive is deleted. I did not have to "eject".
>>
>> Same machine, W4. 4 MSD and a Modem, same as eCS, I think.
>>
>> USB and NET both work. However, It creates five removable drive
>> objects before anything is plugged in. I compared all the USB files
>> could find to my downloads and th eCS installation. No obvious
>> difference I can see.
>>
> Same machine, different HDD, new eCS20RC2, 4 MSD.
>
> It creates five removables objects, just like W4.
>
> eCenter takes two minutes, thirty seconds to load.
>
> Attempt to log on net gets: Exception in module: SOCKETS, TRAP 000e.
>
> I don't need to buy video games, I have eCS.

Same machine, another new install, 4 MSD.

No unused removables objects, nor does the system find the card when I
plug it in and put up a "found" box. It waits until "Refresh" and then
creates an object without any notice. Unplugging the card and then the
bay does not cause the object to be deleted, nor does "Refresh".

How do I get it to behave like the case described above where I compared
it to W2K?

Ray

This is the second time I sent this. First time I got:

This Message was undeliverable due to the following reason:

Your message was not delivered because the destination computer was
not found. Carefully check that it was spelled correctly and try
sending it again if there were any mistakes.

It is also possible that a network problem caused this situation,
so if you are sure the address is correct you might want to try to
send it again. If the problem continues, contact your friendly
system administrator.

The following recipients did not receive this message:

=====================================================

To unsubscribe from this list, send an email message
to "steward@scoug.com". In the body of the message,
put the command "unsubscribe scoug-help".

For problems, contact the list owner at
"postmaster@scoug.com".

=====================================================

Return to [ 17 | October | 2007 ]

SCOUG, Warp Expo West, and Warpfest are trademarks of the Southern California OS/2 User Group. OS/2, Workplace Shell, and IBM are registered trademarks of International Business Machines Corporation. All other trademarks remain the property of their respective owners.